Chapter 3
| Basic Management Tasks
Resetting the System
– 113 –
Resetting the System
Use the System > Reset menu to restart the switch immediately, at a specified time,
after a specified delay, or at a periodic interval.
Command Usage
◆ This command resets the entire system.
◆ When the system is restarted, it will always run the Power-On Self-Test. It will
also retain all configuration information stored in non-volatile memory. (See
“Saving the Running Configuration to a Local File” on page 91).
Parameters
The following parameters are displayed:
System Reload Information
◆ Reload Settings – Displays information on the next scheduled reload and
selected reload mode as shown in the following example:
“The switch will be rebooted at March 9 12:00:00 2012. Remaining
Time: 0 days, 2 hours, 46 minutes, 5 seconds.
Reloading switch regularly time: 12:00 everyday.”
◆ Refresh – Refreshes reload information. Changes made through the console or
to system time may need to be refreshed to display the current settings.
◆ Cancel – Cancels the current settings shown in this field.
System Reload Configuration
◆ Reset Mode – Restarts the switch immediately or at the specified time(s).
■
Immediately – Restarts the system immediately.
■
In – Specifies an interval after which to reload the switch. (The specified
time must be equal to or less than 24 days.)
■
hours – The number of hours, combined with the minutes, before the
switch resets. (Range: 0-576)
■
minutes – The number of minutes, combined with the hours, before the
switch resets. (Range: 0-59)
■
At – Specifies a time at which to reload the switch.
■
DD - The day of the month at which to reload. (Range: 01-31)
■
MM - The month at which to reload. (Range: 01-12)
To Next Page
Loading...
