Chapter 8
| Authentication Commands
PPPoE Intermediate Agent
– 293 –
telnet-client - Displays IP addresses for the Telnet group.
Command Mode
Privileged Exec
Example
Console#show management all-client
Management Ip Filter
HTTP-Client:
Start IP address End IP address
-----------------------------------------------
1. 192.168.1.19 192.168.1.19
2. 192.168.1.25 192.168.1.30
SNMP-Client:
Start IP address End IP address
-----------------------------------------------
1. 192.168.1.19 192.168.1.19
2. 192.168.1.25 192.168.1.30
TELNET-Client:
Start IP address End IP address
-----------------------------------------------
1. 192.168.1.19 192.168.1.19
2. 192.168.1.25 192.168.1.30
Console#
PPPoE Intermediate Agent
This section describes commands used to configure the PPPoE Intermediate Agent
(PPPoE IA) relay parameters required for passing authentication messages between
a client and broadband remote access servers.
Table 50: PPPoE Intermediate Agent Commands
Command Function Mode
pppoe intermediate-agent Enables the PPPoE IA globally on the switch GC
pppoe intermediate-agent
format-type
Sets the access node identifier and generic error message
for the switch
GC
pppoe intermediate-agent
port-enable
Enables the PPPoE IA on an interface IC
pppoe intermediate-agent
port-format-type
Sets the circuit-id or remote-id for an interface IC
pppoe intermediate-agent
port-format-type remote-
id-delimiter
Sets the remote-id delimiter for an interface IC
pppoe intermediate-agent
trust
Sets the trust mode for an interface IC
pppoe intermediate-agent
vendor-tag strip
Enables the stripping of vendor tags from PPPoE Discovery
packets sent from a PPPoE server
IC
To Next Page
Loading...
