Chapter 21
| VLAN Commands
Editing VLAN Groups
– 581 –
Related Commands
garp timer (577)
show gvrp
configuration
This command shows if GVRP is enabled.
Syntax
show gvrp configuration [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1-8)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-16)
Default Setting
Shows both global and interface-specific configuration.
Command Mode
Normal Exec, Privileged Exec
Example
Console#show gvrp configuration ethernet 1/7
Eth 1/ 7:
GVRP Configuration : Disabled
Console#
Editing VLAN Groups
vlan database This command enters VLAN database mode. All commands in this mode will take
effect immediately.
Default Setting
None
Table 106: Commands for Editing VLAN Groups
Command Function Mode
vlan database Enters VLAN database mode to add, change, and delete
VLANs
GC
vlan Configures a VLAN, including VID, name and state VC
To Next Page
Loading...
