Chapter 12
| Security Measures
Network Access (MAC Address Authentication)
– 304 –
Web Interface
To configure MAC authentication on switch ports:
1. Click Security, Network Access.
2. Select Configure Interface from the Step list.
3. Click the General button.
4. Make any configuration changes required to enable address authentication on
a port, set the maximum number of secure addresses supported, the guest
VLAN to use when MAC Authentication or 802.1X Authentication fails, and the
dynamic VLAN and QoS assignments.
5. Click Apply.
Figure 181: Configuring Interface Settings for Network Access
Configuring
Port Link Detection
Use the Security > Network Access (Configure Interface - Link Detection) page to
send an SNMP trap and/or shut down a port when a link event occurs.
Parameters
These parameters are displayed:
◆ Link Detection Status – Configures whether Link Detection is enabled or
disabled for a port.
◆ Condition – The link event type which will trigger the port action.
â–
Link up – Only link up events will trigger the port action.
â–
Link down – Only link down events will trigger the port action.
â–
Link up and down – All link up and link down events will trigger the port
action.
To Next Page
Loading...
Need help?
General