– 83 –
3 Basic Management Tasks
This chapter describes the following topics:
◆ Displaying System Information – Provides basic system description, including
contact information.
◆ Displaying Hardware/Software Versions – Shows the hardware version, power
status, and firmware versions
◆ Configuring Support for Jumbo Frames – Enables support for jumbo frames.
◆ Displaying Bridge Extension Capabilities – Shows the bridge extension
parameters.
◆ Managing System Files – Describes how to upgrade operating software or
configuration files, and set the system start-up files.
◆ Setting the System Clock – Sets the current time manually or through specified
NTP or SNTP servers.
◆ Configuring the Console Port – Sets console port connection parameters.
◆ Configuring Telnet Settings – Sets Telnet connection parameters.
◆ Displaying CPU Utilization – Displays information on CPU utilization.
◆ Displaying Memory Utilization – Shows memory utilization parameters.
◆ Stacking – Sets master unit, enables stacking on 10G ports, renumbers the units
in the stack.
◆ Resetting the System – Restarts the switch immediately, at a specified time,
after a specified delay, or at a periodic interval.
To Next Page
Loading...
Need help?
General