Edge-Core ECS4620-28F - Figure 466: Clearing Entries from the Routing Table; Specifying Network Interfaces

Chapter 19 | Unicast Routing
Configuring the Routing Information Protocol
– 703 –
◆ Clear Route By Network – Clears a specific route based on its IP address and
prefix length.
■
Network IP Address – Deletes all related entries for the specified network
address.
■
Prefix Length – A decimal value indicating how many contiguous bits
(from the left) of the address comprise the network portion of the address.
Web Interface
To clear entries from the routing table RIP:
1. Click Routing Protocol, RIP, General.
2. Select Clear Route from the Action list.
3. When clearing routes by type, select the required type from the drop-down list.
When clearing routes by network, enter a valid network address and prefix
length.
4. Click Apply.
Figure 466: Clearing Entries from the Routing Table
Specifying
Network Interfaces
Use the Routing Protocol > RIP > Network (Add) page to specify the network
interfaces that will be included in the RIP routing process.
Command Usage
◆ RIP only sends and receives updates on specified interfaces. If a network is not
specified, the interfaces in that network will not be advertised in any RIP
updates.
◆ No networks are specified by default.