To Next Page

To Previous Page

D-34 Connectrix DS-32M2 User Guide

Command Line Interface

Parameter This command has one parameter.

Command Examples

Root> config switch rerouteDelay true

Root> config switch rerouteDelay 1

config.switch.speed

Syntax speed switchSpeed

Purpose This command sets the speed for the switch.

Description The switch must be set off line before this command is entered.

A switch can be configured to operate at 1 Gb/sec or 2 Gb/sec.

Parameters This command has one required parameter.

Command Examples

Root> config switch speed 2g

config.switch.show

Syntax show

Purpose This command shows the switch configuration.

Parameters This command has no parameters.

Command Example

Root> config switch show

Output The switch configuration data is displayed as a table that includes the

following properties:

rerouteDelayState

Specifies whether Rerouting Delay is

enabled. Valid values are true and false.

Boolean 1 or 0 may be substituted as values.

switchSpeed Specifies the speed of the switch. Valid values

are 1g (for 1 Gb/s) or 2g (for 2 Gb/s).

Questions and Answers:

Need help?

Do you have a question about the EMC Connectrix DS-32M2 and is the answer not in the manual?

EMC Connectrix DS-32M2 Specifications

General