EMC Connectrix DS-32M2 - Page 285

D
CLI OverviewThe config Branch
D-37
Command Line Interface
config.system.location
Syntax location “systemLocation”
Purpose This command sets the system location attribute.
Parameters This command has one parameter.
Command Example
Root> config system location “Everywhere”
config.system.name
Syntax name “systemName”
Purpose This command sets the system name attribute.
Parameters This command has one required parameter.
Command Example
Root> config system name “Joe’s Switch”
config.system.show
Syntax show
Purpose This command shows the system configuration.
Parameters This command has no parameters.
Command Example
Root> config system show
Output The system configuration is displayed as a table similar to that shown
under Output Examples.
systemLocation
Specifies the new system location for the switch.
The location can contain up to 255 characters.
systemName
Specifies the new system name for the switch.
The name can contain up to 24 characters.