EMC Connectrix DS-32M2 - Page 288

D
D-40 Connectrix DS-32M2 User Guide
Command Line Interface
config.zoning.clearZoneSet
Syntax clearZoneSet
Purpose This command clears the zone set contained in the work area,
removing all zones, and takes effect immediately.
Description This command does not change the zone set name.
Parameters This command has no parameters.
Command Example
Root> config zoning clearZoneSet
config.zoning.addZone
Syntax addZone “zoneName”
Purpose This command adds a new (empty) zone to the zone set in the work
area.
Description Changes are not activated on the switch until the
config.zoning.activateZoneSet command is issued. The CLI
supports the number of zones per zone set specified for a given
product.
Parameters This command has one parameter.
Command Example
Root> config zoning addZone TheUltimateZone
zoneName
Specifies the name of the new zone. The
zoneName must contain 1 to 64 characters.
Valid characters are:
ABCDEFGHIJKLMNOPQRSTUVWXYZabcd
efghijklmnopqrstuvwxyz0123456789$-^_
Spaces are not permitted, and the first character
must be alphabetical.