Fargo DTC550 - Resolving the Flipper Alignment Error Message

FOR RESTRICTED USE only Fargo Electronics, Inc.
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
4-35
Resolving the Flipper Alignment Error Message
Symptom: A Flipper Alignment error was displayed on the LCD.
Step Procedure
1 Check for any obstruction.
a. Open the Top Lid.
b. Remove the Ribbon.
c. Ensure that there are no obstructions.
2 Verify the Motor operation.
a. Test the Flipper Table Home Sensor (A000136) by rotating the Flipper
Table off from the level position.
b. Close the Top Cover.
(Note: This should cause the Flipper Table to attempt to home itself.)