Fargo DTC550 - Switching to the Automatic IP Address Mode

FOR RESTRICTED USE only Fargo Electronics, Inc.
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
7-20
Switching to the automatic IP address mode
Step Procedure
1 Select the Network link from any web page of the Printer.
2 Select the Obtain an IP address automatically radio button to enable the
DHCP/BOOTP, which automatically assigns the network settings.
Even with this button selected, the User can enter Stored Settings, and the
Stored Settings will remain in memory. See below. (Note: This is the default
method.)
3 Click on the Submit button to save this setting.
4 Login as a root User if you are so prompted. (Note: Any change of setting
will only be accepted after you have successfully logged in.)
5 Reboot the Printer to affect this change. See the procedures in Using the
Reboot pages.