Fargo DTC550 - Selecting the Verimark Radio Button

FOR RESTRICTED USE only Fargo Electronics, Inc.
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
6-82
Selecting the VeriMark radio button
Step Procedure
1 Click on either the VeriMark or HoloMark radio button, as shown below. The
foil options are used to control the size of the exclusion area. (Note: When
VeriMark is selected a rectangle-sized area is excluded, HoloMark uses a
square sized area.)
2 Click on the VeriMark radio button (below) for the rectangle-sized area.