FOR RESTRICTED USE only Fargo Electronics, Inc.
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
6-38
Using the Printer Calibration Utility
Access the Settings dialog box via the Settings button on the Calibrate tab. Use the
adjustment mode to change the Printer's internal settings. (Note: The Card Printer is
equipped with an internal adjustment mode programmable through the Settings dialog
box. This dialog box is accessible only if the Printer is powered ON, it is in Ready Mode
and it is properly connected to the PC.)
Caution! These settings are optimized at the factory. In most cases, these
settings can be used without changing them.
To Next Page
Loading...
Need help?
General
