Fargo DTC550 - Saving Addresses; Resetting Passwords

FOR RESTRICTED USE only Fargo Electronics, Inc.
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
7-57
Saving addresses
Step Procedure.
1 See the Accessing the Network Setup Menu procedure to access the
Network Settings menu (MENU -> Setup Printer -> Network Settings).
2 Select down arrow on the LCD to view the Save Addresses menu entry.
3 Press the Select button to save the current network settings (IP address,
GW, SN Mask) as the stored settings which will be used when automatic
address assignment using DHCP is disabled.
Resetting Passwords
Step Procedure
1 See the Accessing the Network Setup Menu procedure to access the
Network Settings menu (MENU -> Setup Printer -> Network Settings).
2 Select down arrow on the LCD to view the Reset Passwords menu entry.
3 Press the Select button to reset the User passwords to the default settings
of empty strings.
(Note: This can be used when the passwords are not known.)