Fargo DTC550 - Disabling the Mag Verify Process on the DTC550 Printer; Adjusting the White Level

FOR RESTRICTED USE only Fargo Electronics, Inc.
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
11-25
Disabling the Mag Verify process on the DTC550 Printer
The LCD tree shows a method to disable verification of the magnetic encoding on all
encoded cards. See Selecting from the Menu Option Structure Tree
.
Caution: This setting should not be used under normal circumstances (since this
setting will discontinue any indication of success or failure for the Magnetic Encoding).
Contact Fargo Technical Support
to use this control.
Adjusting the White Level
Use this option to reduce any noticeable image transfer in the white areas of the card image.
Step Procedure
1 Select MENU, Setup Printer, Print Settings and White Level.
2 Press the UP arrow to increase this setting, which will reduce the
background darkness.
3 Press the DOWN arrow to decrease this setting, which will increase the
background detail.
4
• Press the DONE button to save the value.
• Press YES when asked to save the change.