Fargo DTC550 - Printing a Test Page

FOR RESTRICTED USE only Fargo Electronics, Inc.
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
7-62
Verifying that your PC can access the Printer using the ping command
(continued)
Step Procedure
2 Verify that the PC and the Printer are connected to the same network.
3 You may be on different subnets of your network and some of the network
settings for the Printer are not correct. See your network administrator about
this.
(Note: The subnet mask must be the same as other devices on the
network, and that the unique IP address is part of the network specified by
the subnet mask.)
Printing a test page
Step Procedure
1 Try printing a test page from the Printer Driver properties window.
See Frequently-asked Questions
.
2 If you cannot print a test page, then consider the following:
• There may be an error at the Printer.
• There may be a job in the Windows print queue which has stalled.
• The Printer may be paused or set to operate offline in the Windows print
queue.