FOR RESTRICTED USE only Fargo Electronics, Inc.
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
3-2
Introduction
The following guide will walk you through the installation of the Fargo DTC550 Direct to Card
Printer/Encoder Printer Driver, Diagnostic Utility, Print Ribbon and Cards.
Time Requirement
• Time Requirement (software): This software installation process will require
approximately 2 to 5 minutes (depending on the speed of your PC).
• Time Requirement (Printer): The time required to set up a standard DTC550 Printer
would be approximately 5 to 10 minutes.
System Requirements
The System Requirements are as follows:
• IBM-PC or compatible, Windows 2000/XP, x86 300MHz computer with 64MB of RAM or
higher, 200MB free hard disk space or higher, USB 1.1
To Next Page
Loading...
