Fargo DTC550 - Loading the Overlaminate

FOR RESTRICTED USE only Fargo Electronics, Inc.
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
3-14
Loading the Overlaminate
(Note: This procedure only applies to the DTC550 with Laminating Card Printer/Encoder.)
The loading process for both the Thermal Transfer Film and the PolyGuard™ Overlaminate
material is the same. Refer to the following steps to load either type of overlaminate into the
Printer.
Danger: Do not touch the metal Lamination Shield or the Lamination Roller when
loading the overlaminate. These components can become very hot.
Step Procedure
1 Open the Lamination Module's Top Cover.