FOR RESTRICTED USE only Fargo Electronics, Inc.
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
7-52
Restoring the Factory Settings for Ethernet
There may be times when you are unable to use the current configuration of the
Ethernet interface. (Note: This could be because you have lost the password for your
Printer or you just cannot get it to work properly.)
Resetting the DTC550 settings
The DTC550 has a menu selection that allows the User names and passwords to revert
to default. To reset these settings, select: Menu : Setup Printer : Network Settings :
Reset Passwords.
Reviewing the DTC550 Network Settings
The DTC550 printer/encoder will display new menu entries when the Ethernet option is
installed, and the Printer has established communications to a host device. You can use
these procedures to view network settings by using the new LCD settings.
Reviewing the DHCP setting
Step Procedure
1 See the Accessing the DTC550 IP address procedure to access the
Network Info menu (MENU -> System Info -> Network Info).
2 Select the up or down arrow on the LCD to view the DHCP menu entry.
• DHCP Enabled indicates that automatic IP assignment is selected.
• DHCP Disabled indicates that static IP assignment is selected.
Reviewing the Gateway Setting
Step Procedure
1 See the Accessing the DTC550 IP address procedure to access the
Network Info menu (MENU -> System Info -> Network Info).
2 Select the up or down arrow on the LCD to view the GW: menu entry.
DHCP Enabled indicates that automatic IP assignment is selected.
DHCP Disabled indicates that static IP assignment is selected.
3 View the gateway address displayed as a dotted quad number.
Example: GW: 168.192.1.1
To Next Page
Loading...
