Fargo DTC550 - Upgrading the Main Firmware with the Fargo Diagnostics Utility

FOR RESTRICTED USE only Fargo Electronics, Inc.
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
7-50
Upgrading the Main Firmware with the Fargo
Diagnostics Utility
The Main Printer Firmware upgrades are done with the same procedure as the USB-
connected Printer. The PC doing the upgrade must have a Driver installed for the Fargo
Printer to be upgraded. (Note: Alternatively, a DTC550 User can upgrade the DTC550
Main Printer Firmware by using the DTC550 Upgrade web page.)
Step Procedure
1 Run the Fargo Diagnostic Utility by selecting from the start menu the following:
Start -> Programs -> Fargo -> Fargo Diagnostic Utility
2 Select the Fargo Printer to upgrade from the drop-down box.
3 Go to the Firmware Updates tab.
4 If you need to download the update file from the Internet, then select the
Download Firmware button.
5 Choose the update file with the Select Firmware button.
6 Put your Printer into the upgrade mode. Refer to the appropriate service
manual for your specific Fargo card printer.
7 Select the Send Firmware button.