FOR RESTRICTED USE only Fargo Electronics, Inc.
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
4-37
Resolving a Program Exception Error
Symptom: An error has occurred in the Printers Firmware causing a Program
Exception Error.
Step Procedure
1 Restart the Printer and attempt to print the card again.
If no Error is displayed, continue printing.
If a Program Exception is displayed again, continue to step 2.
2 Reload the Firmware.
3 Replace the Main Board. (Note: The Main Board can only be replaced by
an Authorized Service Provider.)
To Next Page
Loading...
