Fargo DTC550 - Upgrading the Main Firmware

FOR RESTRICTED USE only Fargo Electronics, Inc.
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
7-43
Upgrading the Main Firmware
The Upgrade page allows the User to upload new Firmware to the Printer. For the
DTC550 printer/encoder, this Upgrade page provides for upgrading the main Printer
Firmware which includes the Print Server Firmware.
It is only available to the DTC550 after the Printer has been rebooted into the upgrade
mode.
Step Procedure
1 Select the Administration link.
2 Go to step 7 if the Upgrade link is shown.
3 Select the Reboot link if the Upgrade link is not shown.