FOR RESTRICTED USE only Fargo Electronics, Inc.
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
11-27
Adjusting the Flipper Offset
Step Procedure
1 Select MENU, Setup Printer and Flipper Settings.
2 Select Print Flip Level, Print Flip Angle or Encoder Angle.
• Use the Print Flip Level option to set the position of the Flipper so it
is level with the card path.
• Use the Print Flip Angle option to set the position of the Flipper to
ensure it is level when the card is flipped.
• Use the Encoder Flip Angle option to fine tune the position of the
Flipper in relation to the Printer's built-in Encoder if your Printer is
equipped with this option.
3 Change these settings in small increments if the card is not feeding
correctly off the Card Flipper onto the card path or into the Encoder.
• Decrease the setting to lower the lip of the Flipper.
• Increase the setting to raise it.
4 Press the DONE button to save the value. Press YES when asked to save
the change.
Viewing the Report Supplies
Step Procedure
1 When using monochrome resin-only print Ribbons, use this option to view
all of the following information about the print Ribbon installed in the
Printer.
2 When using Dye-Sublimation print Ribbons, it is possible to view only the
Type, Part Number fields and Prints Left.
Select the Menu > System Info > Report Supplies.
• Type: This displays the name or type of print Ribbon installed.
• Prints Left: This displays the approximate number of prints
remaining on your Ribbon. This information is helpful for determining
about how many cards you can produce before the next Ribbon
change. (Note: Prints Left is displayed as a percentage remaining
for monochrome resin-only Ribbons.)
• Part Number: This displays the specific part number for your Ribbon
which can be helpful when re-ordering.
To Next Page
Loading...
