FOR RESTRICTED USE only Fargo Electronics, Inc.
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
4-14
Communications Errors
Resolving the Communication Errors
Symptom(s): Incorrect output, communications error on PC or Printer, stalling, no
response from Printer or no job printed.
Step Procedure
1 Confirm that the system meets the minimum requirements, as shown here:
Windows® 2000 with Service Pack 4
Windows® XP with Service Pack 2
Windows® Server 2003
x86 300 MHz computer with 64 MB of RAM or higher
200 MB free hard disk space or higher
USB 1.1
2 Confirm the correct installation of the Printer Driver.
Close the software program and check the Printer Driver.
Reboot the computer.
Ensure the Printer Driver is installed correctly. (Note: Especially if an
obsolete Driver was recently removed.)
Ensure the correct setup options within the Printer Driver are selected.
Confirm that the Driver is current by checking at:
www.fargo.com
To Next Page
Loading...
