FOR RESTRICTED USE only Fargo Electronics, Inc.
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
4-13
Troubleshooting the LCD Messages (continued)
LCD Message Cause Solution
WRONG LAM
TYPE ERROR
See the next column. Install a new film roll and press
RESUME to continue or CANCEL
to abort. If the problem persists, call
for technical assistance.
WRONG RIBBON
OEM
The OEM ID of the print
Ribbon installed in the
Printer does not match
the OEM ID set in the
Printer.
Get the correct Ribbon from your
dealer. Press RESUME to continue
or CANCEL to abort.
WRONG RIBBON
TYPE
The print Ribbon installed
in the Printer does not
match the Ribbon type
selected in the Printer
Driver or a Self-test job
cannot be printed with
the print media installed
or the Ribbon must
contain YMC panels for
Sensor calibration.
Change either accordingly. Press
RESUME to continue or CANCEL
to abort.
To Next Page
Loading...
