Fargo DTC550 User Manual

FOR RESTRICTED USE only Fargo Electronics, Inc.
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
4-39
Resolving the Pixel failure problems (continued)
Step Procedure
4 Replace the Cleaning Roller.
a. Open the Printer's Top Cover.
b. Pull the Cleaning Cartridge out of the Printer.
c. Remove the old roller from the Cleaning Cartridge and replace it with the
new roller.
d. Pull on the Cleaning Roller's tab to remove the backing from the tape.
e. Insert the Cleaning Cartridge back into the Printer.
f. Be sure to push down on the cartridge until it clicks into place.
5 Clean the Platen Roller.
a. Leave the Printer power ON and open the Top Cover and Printhead
Arm.
b. Remove the Print Ribbon.
c. Locate the Print Platen Roller.
d. Use a Cleaning Pad from the Printer Cleaning Kit to wipe the Roller
clean.
e. Use a Cleaning Pad from the Printer Cleaning Kit to wipe the Roller
clean. Press the FWD and REV buttons to move the Roller back and
forth while cleaning.
f. Replace the Print Ribbon.
g. Close the Printer after the Rollers are clean and completely dry.
6 Replace the Printhead.

Fargo DTC550 Specifications

General

Brand	Fargo
Model	DTC550
Category	Printer
Language	English