FOR RESTRICTED USE only Fargo Electronics, Inc.
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
5-17
Performing the procedure for the DTC550 Card Lamination Module
Attachment Kit (continued)
Step Procedure
12 Once all print supplies are installed, apply power to the Lamination Module
and run a test print to make sure installation was successful.
You must have PolyGuard™ overlaminate and a full-color Print Ribbon
installed to print this test image.
To test, go to the Printer’s LCD display and select MENU, PRINT TEST
IMAGE and make sure that Lamination is set to ON. Then select any image
from the test images.
The test image will begin printing after a few seconds and will both print and
laminate the card.
13
You have completed the procedure.
To Next Page
Loading...
