Fargo DTC550 - Page 245

FOR RESTRICTED USE only Fargo Electronics, Inc.
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
6-67
Selecting the Lamination Type
Step Procedure
1B Select the 0.6 PolyGuard Lamination option or 1.0 PolyGuard
Lamination option for either patch thickness. (Note: These both offer
equivalent protection but require different heat settings and lamination
speeds.
• Select the appropriate option according to the thickness of the
PolyGuard material you are using.
OR
• Select the PolyGuard Alternating Patch option only if using
PolyGuard material that has alternating patch configurations on the
same roll (e.g., full patch on the front of the card and half patch on the
back).