FOR RESTRICTED USE only Fargo Electronics, Inc.
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
6-75
Using the Overlay/Print Area (continued)
See the previous procedure in this section.
Step Procedure
4 Follow this procedure once the area is sized properly.
a. Measure the location where this desired area is to be positioned on the
card.
b. Measure from the lower left corner of the card (up and over) to the lower
left corner (for the defined area to begin).
c. Enter these values into the X and Y boxes. (Note: The card grid lines
are spaced at .2 inch/5mm intervals.)
To Next Page
Loading...
