FOR RESTRICTED USE only Fargo Electronics, Inc.
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
7-67
Reviewing Frequently-asked Questions (continued)
Question Answer
How do I reconfigure my
PC Printer Driver to
connect to a different
Printer or different IP
address?
Follow this procedure.
1. Run the Fargo Add Printer Wizard program by
choosing from the Start menu: Go to the Start ->
Programs -> Fargo -> Fargo Add Printer Wizard.
2. Select Next on the first window.
3. On the second window, specify the type of Printer you
want and ask for a network connected Printer. Select
Next.
4. Enter the IP address of your new Printer connection.
Select Next.
5. Select Finish.
How can I verify/change
what IP address my
installed Printer Driver is
expecting to find my
Printer?
Follow this procedure.
1. Open the Printer Driver properties window.
2. Select Start -> Settings -> Printers and Faxes -> [your
Printer Driver] -> Properties.
3. From the Ports tab, select Configure Port.The Host
name will indicate IP address of the connected Printer.
(Note: If this does not match your Printer’s IP
address, you can change it from this window.)
4. Enter the correct IP address.
5. Select OK.
6. Select Apply.
7. Select Close.
8. Specify the new IP address.
9. Select: Next, Next, Finish and Close.
10. Select Apply.
11. Select Close.
Continued on the next page
To Next Page
Loading...
