To Next Page

To Previous Page

5 Tools

130

Tools

System Settings Procedure

To change or customize the system settings, enter the System Administration mode.

This section describes the basic procedures for system settings. The following shows

the reference section for each procedure.

Step 1 Entering System Administration Mode .........................................................................130

Step 2 Entering the System Administrator User ID and Passcode ...........................................130

Step 3 Selecting [Tools]............................................................................................................131

Step 4 Selecting a Setting Item on the [Tools] Screen..............................................................131

Step 5 Setting a Feature ............................................................................................................133

Step 6 Exiting System Administration Mode ...........................................................................133

Step 1 Entering System Administration Mode

Press the <Log In/Out> button or the login

information field on the touch screen.

Step 2 Entering the System Administrator User ID and Passcode

To enter the System Administration mode, enter the system administrator User ID. If

[Passcode Entry from Control Panel] is set to [On] under [Authentication/Security

Settings] > [Authentication] > [Passcode Policy], you need to enter the passcode.

We recommend that you change the system administrator user ID and passcode

immediately after installing the machine.

For more information on how to change the passcode, refer to "System Administrator Settings" (P.283).

1 Enter the system administrator’s user ID with

the numeric keypad or the keyboard

displayed on the screen, and select [Enter].

When a passcode is required, select [Next]

and enter the system administrator’s

passcode, and then select [Enter].

Note • The default user ID is "11111".

• The default passcode is "x-admin".

• The screen may differ depending on the settings of the machine.

• The <Log In/Out> button is lit when the machine enters the System Administration mode.

<Log In/Out> button

Fuji Xerox ApeosPort-IV C7780 Administrator's Guide

Other manuals for Fuji Xerox ApeosPort-IV C7780