EasyManuals Logo

Fuji Xerox ApeosPort-IV C7780 Administrator's Guide

Fuji Xerox ApeosPort-IV C7780
739 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #314 background imageLoading...
Page #314 background image
7 Printer Environment Settings
314
Printer Environment Settings
7
3 Set an IP address and the other addresses.
Skip this step if an IP address is already set.
If DHCP or BOOTP is available in your environment, configure the method for
obtaining the address. The configuration of an IP address, a subnet mask, and a
gateway address is not required.
For information on how to set an IP address, refer to "Protocol Settings" (P.196).
4 Select [Close] repeatedly until the [Tools] screen is displayed.
5 Select [Close].
Note • Rebooting the machine may be required depending on the settings. When a message
displayed on the screen, follow the message and reboot the machine.
6 Print a configuration report to confirm that the IPP port is enabled and that TCP/IP is
set up correctly.
For information on how to print a configuration report, refer to "Print Reports" (P.111).
7 Configure other IPP settings as necessary.
Refer to "CentreWare Internet Services Setting Items" (P.314).
Step 3 Configuration on the Computer
To print from the machine, you need to install a print driver on your computer.
For information on the supported operating systems, refer to "Supported Operating Systems" (P.302).
For information on the driver installation procedures, refer to the manual contained in the Driver CD
Kit.
CentreWare Internet Services Setting Items
You can configure the following setting items using CentreWare Internet Services:
For details on the setting items, click [Help] at the upper right corner of the CentreWare Internet
Services screen to see help.
For information on how to start CentreWare Internet Services, refer to "Starting CentreWare Internet
Services" (P.296).
z
Spool Destination for Jobs
([Properties] > [General Setup] > [Memory Settings] > [IPP])
z
Port Settings
z
Add Port Number
z
TBCP Filter
Note • The TBCP filter can be configured when the Adobe PostScript 3 Kit (optional) is installed.
z
Administrator Mode
z
DNS
z
Connection Time-Out

Table of Contents

Other manuals for Fuji Xerox ApeosPort-IV C7780

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fuji Xerox ApeosPort-IV C7780 and is the answer not in the manual?

Fuji Xerox ApeosPort-IV C7780 Specifications

General IconGeneral
BrandFuji Xerox
ModelApeosPort-IV C7780
CategoryAll in One Printer
LanguageEnglish

Related product manuals