Activity Report
721
Appendix
16
Activity Report
You can print activity reports to check whether a transmission is successfully
completed or not. In the report, a remote terminal name and a result or a status of each
operation are recorded by outgoing and incoming transmission.
For information on how to print the activity report, refer to "Print Reports" (P.111).
Item Description
No. The serial numbers for transmissions is shown.
Doc. Job numbers that the machine automatically assigned to
documents when the documents were received.
Remote Station Information on recipient to which transmission is made is
recorded in the following order of priority.
Transmitting (speed dialing)
cRecipient
dRemote terminal name
eG3 ID (including spaces)
fTel. No.
When IP Fax (SIP) is used:
fSIP address
gCommunication mode IP Fax or IP Fax-ECM
gCommunication mode EC (or G3, SG3)
Transmitting (when all digits are dialed)
cRemote terminal name
dG3 ID (including spaces)
eTel. No.
fCommunication mode EC (or G3, SG3)
When IP Fax (SIP) is used:
fSIP address
gCommunication mode IP Fax or IP Fax-ECM
Receiving
cRemote terminal name
dG3 ID (including spaces)
eCommunication mode EC (or G3, SG3)
When IP Fax (SIP) is used:
eCommunication mode IP Fax or IP Fax-ECM
Note • You can set the number of character digits displayed for
the recipient whether the first 40 digits or the last 40
digits. For details on setting up, see "Activity Report -
Recipient" (P.162). The factory default displays the first
40 digits.
Start Time The date and time that the communication began are shown.
In Batch Send, the start time of the transmission for each doc-
ument is recorded.
Duration The duration of the transmission is displayed. In Batch Send,
it is the length of time taken to transmit each document is
recorded.