2 Paper and Other Media
60
Paper and Other Media
2
4 Load and align the edge of the paper against
the left edge of the tray with the side to be
copied or printed on facing down.
Important • Do not load paper exceeding the
maximum fill line. It might cause paper
jams or machine malfunctions.
5 Push the tray in gently until it comes to a stop.
Important • When pushing the paper tray in, do it slowly. If the tray is pushed with too much force, it
might cause machine malfunctions.
Note • Affix the paper size label to the front of the paper tray.
6 Specify the type of the paper loaded when you have changed the paper type.
For information on how to set the paper types, refer to "Changing the Paper Settings" (P.65).
Changing the Paper Size for Tray 4
The following describes how to change the paper size for Tray 4.
1 Pull out Tray 4 towards you until it stops.
Important • While the machine is processing a job, do not pull the tray out that the job uses.
• Do not add a new stack of paper on top of the remaining paper in the tray to prevent paper
jams or any other troubles. First, remove the remaining paper in the tray, and then load the
new stack of paper.
2 Remove any paper loaded in the tray.
3 Hold the paper guide and slide it to the
desired paper size.
CAUTION
Make sure to pull out the tray
slowly. When the tray is being
pulled out with force, the tray
may possibly hit your knees or
other parts of your body causing
injuries.
To Next Page
Loading...
Need help?
General
