Fold Position Adjustment
627
Appendix
16
Fold Position Adjustment
This section describes how to adjust the fold position.
You can adjust the fold position for each paper type, and save 10 types of adjusted
values. You can assign a set type to each tray.
You can adjust the fold position for single fold, booklet, C fold, Z fold, Z fold half sheet.
Fold Position Adjustment
1
Load the paper to adjust the fold position in the tray.
2 Press the <Log In/Out> button.
For more information on how to enter the System
Administration mode, refer to "System Settings
Procedure" (P.130).
3 Enter the system administrator’s user ID with
the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a password is required, select [Next]
and enter the system administrator’s
passcode, and select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
4 Select [Tools] on the [Services Home]
screen.
5 Select [Common Service Settings] >
[Maintenance].
<Log In/Out> button
To Next Page
Loading...
Need help?
General
