Common Service Settings
163
Tools
5
Delete All Data
This feature is designed to prevent the leakage of confidential information of a customer
when the machine is returned to Fuji Xerox. By executing [Start], all data registered on the
machine is deleted.
Do not use this feature normally.
Software Options
This feature is for service representative use. For more information, contact our Customer
Support Center.
Adjust Image Position
Adjusts the position of the image to print. You can adjust the position for each tray, paper
type, side 1 and side 2 of paper. This feature can be used when you want to print with trim
mark, to cut paper, or to align the position of image on sides 1 and 2 of printout.
X direction denotes the direction of paper feed and Y direction the depth dimension of paper.
Note • Adjust the value bit by bit so that the image may not be run off the edge of paper.
Alignment Adjustment
You can adjust output image (perpendicular angle (rhombic distortion), skew, ratio, and print
position) and set the value to 20 types. Assign the type to each tray. This feature can be used
when you want to print with trim mark, to cut paper, or to align the position of image on sides
1 and 2 of printout.
îš„Alignment Adjustment Type Setup
You can set 20 types for each paper type.
For more information on the setting procedures, refer to "Alignment Adjustment Settings" (P.618).
z
Name
Set the name of type.
z
X Print Position
Adjust the image position in paper feed direction in 0.1 mm increments for side 1 and side 2
of paper. If you want to move the image position to the opposite of the paper feed direction,
set positive number, and set negative number if you want to move to the paper feed direction.
z
Y Print Position
Adjust the image position in a direction perpendicular to paper feed direction in 0.1 mm
increments for side 1 and side 2 of paper. If you want to move the image position to the rear
of the machine, set a positive number, and set a negative number if you want to move to the
front of the machine.
z
X% - Magnification Width
Adjust the image size in paper feed direction in 0.025% increments for side 1 and side 2 of
paper. If you want to enlarge the image size, set positive number, and set negative number
if you want to reduce the image size.
z
Y% - Magnification Length
Adjust the image size in a direction perpendicular to paper feed direction in 0.025%
increments for side 1 and side 2 of paper. If you want to enlarge the image size, set positive
number, and set negative number if you want to reduce the image size.
z
Perpendicularity
Adjust the tilt angle (perpendicularity) of the image in 0.1 mm increments for side 1 and side
2 of paper. If you want to tilt the image to the opposite of the paper feed direction, set positive
number, and set negative number if you tilt the image to the paper feed direction.
z
Skew
Adjust image skewing (squareness) in 0.1 mm increments for both sides 1 and 2.
Specify a positive value to adjust the position of the image in the opposite direction of the
paper feed direction, and a negative value to adjust the image in the paper feed direction.
z
Trays 1 to 6
Assign the type to a tray.
To Next Page
Loading...
Need help?
General
