5 Tools
226
Tools
5
îš„Inch Size
You can select a size from Inch series sizes such as 8.5 x 11" and 11 x 17".
îš„Others
You can select a size from sizes of other than the above series such as photo and postcard
sizes.
îš„Custom Size
You can enter any size. Set the width (X) from 15 to 432 mm, and the height (Y) from 15 to
297 mm in 1 mm increments.
Output Size Defaults
Set the sizes to display in [Output Size] when selecting [Enter Output Size] for scanning
documents at [Reduce/Enlarge] in the [Layout Adjustment] screen.
You can assign any output size to output size buttons. Assigning the output sizes to the
buttons will save your time to specify the size each time.
îš„A/B Series Size
You can select a size from A and B series sizes such as A4 and B5.
îš„Inch Size
You can select a size from Inch series sizes such as 8.5 x 11" and 11 x 17".
îš„Others
You can select a size from other sizes such as photo and postcard.
Reduce/Enlarge Presets
Set the magnifications displayed as [Preset %] which are displayed when [Proportional
%] is selected under [Reduce/Enlarge] in the [Layout Adjustment] screen.
You can assign any magnification to the R/E Preset buttons other than [100%].
îš„Preset %
Select a ratio from standard magnification ratios.
îš„Variable %
You can specify a magnification from 25 to 400% in 1% increments.
Other Settings
You can configure other settings related to the Scan services specifications.
Memory Full Procedure
If there is insufficient hard disk memory while scanning a document, a screen appears asking
you how you want to handle the partially stored data.
Set the process you want the machine to perform for the partially stored data after a certain
time has elapsed in the confirmation screen.
You can set the time until the memory full procedure is carried out. For more information, refer to "Auto
Job Release" (P.150).
îš„Delete Job
Deletes the data partially stored.
îš„Run Job
Treats the read-in data as valid, and start sending the document partially stored.
To Next Page
Loading...
Need help?
General
