2 Paper and Other Media
50
Paper and Other Media
2
1 Open Tray 5 (Bypass).
Note • If necessary, extend the extension flap.
The extension flap can be extended in
two stages. When pulling out the
extension flap, do it gently.
2 Hold the center of the paper guides and slide
them to the desired paper size.
3 Load paper with the side to be copied or
printed on facing up and the top edge
frontward, and insert the paper lightly along
the paper guide until it comes to a stop.
Important • Do not load mixed paper types into the
tray.
• Do not load paper exceeding the
maximum fill line. It may cause paper
jams or machine malfunctions.
Note • When loading tab paper, place the paper with its tab side to the left.
Loading Paper in Tray 6 (HCF2 (2000 sheets))
The following describes the procedure for loading paper in Tray 6 (HCF2 (2000
sheets)) (optional).
When the machine runs out of paper during copying or printing, a message is displayed
on the touch screen. Add paper according to the displayed instructions. Copying or
printing is automatically resumed when paper is added.
Note • Before loading paper in a tray, fan the paper well. It reduces paper jams.
For information about changing the paper size and orientation, refer to "Changing the Paper Size for
Tray 6 (HCF2 (2000 sheets))" (P.61).
1 Pull out Tray 6 towards you until it stops.
Important • While the machine is processing a job, do not pull out the tray.
CAUTION
Make sure to pull out the tray
slowly. When the tray is being
pulled out with force, the tray
may possibly hit your knees or
other parts of your body causing
injuries.
To Next Page
Loading...
Need help?
General
