16 Appendix
630
Appendix
16
Single Fold Position Adjustment
Adjust the single fold position.
1 Select [Single Fold], and then select
[Change Settings].
2 Select [Sheets to be folded], and then select
[Sample Printout].
3 Select the tray in which you loaded paper,
and press the <Start> button.
A sample printout is printed.
4 Select [Close].
5 Check the sample printout, measuring the misaligned amount.
6 Select [Long at Left] or [Long at Right].
7 Enter the value you measured in step 5 in
[Value A Before Adjustment].
8 Select [Adjust].
9 Select [Sample Printout] again to print a sample printout, and check the adjustment
results.
10 Adjust the alignment again if necessary (steps 6 to 8).
11 Select [Save].
To Next Page
Loading...
