EasyManuals Logo

Fuji Xerox ApeosPort-IV C7780 Administrator's Guide

Fuji Xerox ApeosPort-IV C7780
739 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #308 background imageLoading...
Page #308 background image
7 Printer Environment Settings
308
Printer Environment Settings
7
Installation When Using NetWare
This section describes how to install the machine using Netware.
The following shows the reference section for each procedure.
Step 1 Preparations....................................................................................................................308
Step 2 Configuration on the Machine .......................................................................................308
Step 3 Configuration on the Computer .....................................................................................310
CentreWare Internet Services Setting Items .............................................................................310
Step 1 Preparations
The following items are required to set up the machine to use NetWare.
z
NetWare server
z
TCP/IP or IPX/SPX network environment
z
The Driver CD Kit (provided with the machine)
Step 2 Configuration on the Machine
The following describes the configuration procedures to use NetWare on the machine.
Note • You can configure the settings using CentreWare Internet Services or the Driver CD Kit.
For the items that can be configured using CentreWare Internet Services, refer to "CentreWare Internet
Services Setting Items" (P.310). For information on how to configure the setting using the Driver CD
Kit, refer to the manual contained in the Driver CD Kit.
Using IPX/SPX
1 Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator’s user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator’s
passcode, and select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3) Select [Tools] on the [Services Home] screen.
2 Enable the NetWare port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [NetWare], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
3 Select [Close] repeatedly until the [Tools] screen is displayed.
4 Select [Close].

Table of Contents

Other manuals for Fuji Xerox ApeosPort-IV C7780

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fuji Xerox ApeosPort-IV C7780 and is the answer not in the manual?

Fuji Xerox ApeosPort-IV C7780 Specifications

General IconGeneral
BrandFuji Xerox
ModelApeosPort-IV C7780
CategoryAll in One Printer
LanguageEnglish

Related product manuals