Solving Curled Output for the Finisher D2-P with Booklet Maker
597
Problem Solving
15
Solving Curled Output for the Finisher D2-P with Booklet Maker
You can correct the curling of the output by pressing the De-curl button.
The De-curl button functions both in suspension and in operation if the power of the
machine is on.
Note • To change the curling correction mode while the machine is in operation, press the De-curl
button and then the change will be applied immediately.
• Pressing the Reset button on the control panel cannot change the curling correction mode.
1 Check how the output copy is curled.
2 Check that the De-curl button lights up.
Note • When the machine is turned on, the de-
curl mode is set to Auto.
• When you cancel the Energy Saver
mode, the de-curl mode will be set to
Auto.
3 Press the De-curl button.
Note • Pressing the De-curl button toggles the mode between Auto, ON, and OFF.
For more information, refer to "Mode and function of the De-curl button" (P.598).
To Next Page
Loading...
Need help?
General
