15 Problem Solving
554
Problem Solving
15
2 Remove all paper loaded in Tray 5 (Bypass).
Important • When two or more sheets of paper are
loaded, remove all of the sheets from the
tray.
Note • If paper is torn, check for any torn pieces
of paper inside the machine.
3 Close the top cover.
4 Fan the paper you removed making sure that all four corners are neatly aligned.
5 Insert the paper into the tray with the printing
side facing up until its leading edge lightly
comes up against the paper feed entrance.
Note • Do not load paper exceeding the
maximum fill line. It might cause paper
jams or machine malfunctions.
Paper Jams in Tray 5 (Bypass) with HCF B1-S
The following describes how to clear paper jams in Tray 5 (Bypass) when HCF B1-S is
installed.
1 Remove the jammed paper and all paper
loaded in Tray 5 (Bypass).
Important • When two or more sheets of paper are
loaded, remove all of the sheets from the
tray.
Note • If paper is torn, check for any torn pieces
of paper inside the machine.
2 If the paper cannot be removed in step 1,
clear the paper jam by opening the front
cover of the transport unit.
For information about clearing paper jams from the
transport unit, refer to "Paper Jams in Tray 6 (HCF
B1-S)" (P.557).
To Next Page
Loading...
