3 Maintenance
90
Maintenance
3
1 Make sure that the machine has stopped,
and open the right cover of the finisher.
2 Pull out the punch scrap container R4
towards you.
3 Discard all the scraps.
4 Insert the empty punch scrap container into
its original position until it comes to a stop.
5 Close the right cover of the finisher.
Note • A message will be displayed and the machine will not operate if the right cover of the finisher
is even slightly open.
Replacing the Staple Scrap Container for Finisher D2-P with Booklet
Maker
When the Finisher D2-P with Booklet Maker is installed and the staple scrap container
becomes full, a message appears on the touch screen. Replace the staple scrap
container according to the message.
Important • Replace the staple scrap container while the power is on.
CAUTION
Be careful not to get injured by waste staples when detaching a staple dust box.
To Next Page
Loading...
