11 Using the Internet Fax Service
360
Using the Internet Fax Service
11
3) Select [Close].
When [POP3] is selected for [Protocol to Receive E-mail]
Configure the POP3 server.
For information on how to configure the POP3 server, refer to "POP3 Server Settings" (P.205).
5 Configure the server settings for sending e-mails.
Note • To send e-mails, SMTP server settings are required. When [POP3] is selected in [Protocol to
Receive E-mail], configure the SMTP server in [Outgoing/Incoming E-mail Settings].
For information on how to configure the e-mail transmission, refer to "SMTP Server Settings" (P.205).
6 Configure the domain filtering for sending and receiving e-mails as necessary.
For information on how to configure the domain filtering, refer to "Domain Filtering" (P.214).
7 Set up the S/MIME information.
1) Select [Connectivity & Network Setup].
2) Select [Security Settings].
3) Select [S/MIME Settings], and then set the items.
For more information on how to configure S/MIME settings, refer to "S/MIME Settings (ApeosPort
Series Models Only)" (P.211).
8 Select [Close] repeatedly until the [Tools] screen is displayed.
9 Select [Close].
Note • Rebooting the machine may be required depending on the settings. When a message
displayed on the screen, follow the message and reboot the machine.
10 After the machine reboots, you can print a configuration report to confirm that the
settings of each item.
For information on how to print a configuration report, refer to "Print Reports" (P.111).
Step 3 Testing the Internet Fax
Test the Internet fax transmission from the machine.
1 Select [Fax/Internet Fax] on the [Services Home] screen to display the [Fax/Internet
Fax] screen.
2 Select [Internet Fax] from the drop-down menu.
3 Enter a destination address.
4 Press the <Start> button to transmit.
5 Check whether the computer received the e-mail.
If the computer cannot receive the e-mail, refer to "Problem Solving" (P.419).
To Next Page
Loading...
