Notes and Restrictions
689
Appendix
16
z
Exiting the Energy Saver mode activates the entire machine when Copy, Simple
Copy, or Stored Programming are set as the default screen on the touch screen.
z
Exiting the Energy Saver mode activates the entire machine when [Paper Tray
Attributes During Loading] is set to [On].
z
The entire machine exits the Energy Saver mode when you press the <Machine
Status> button, enter the System Administration mode, or select the Stored
Programming service.
z
The machine does not exit the Sleep mode when you use the EP service by EP-BB.
z
When [Tools] > [Connectivity & Network Setup] > [Port Settings] > [Port Status] >
[EtherTalk - Port Status] is set to [Enabled], or [USB] > [USB - Print Mode] is set to
any option other than [Auto], exiting the Energy Saver mode activates the entire
machine.
z
The output device is activated when Secure Print is executed using job tickets of
ContentsBridge Utility.
Notes and Restrictions on the Use of the Copy Feature
îš„Copy Feature
The machine does not offer the Improves Fit feature.
îš„Meter Count for Dual Color and Single Color Copies
Dual color and single color copies are counted as color copies.
îš„Color Effect for Dual Color Copy
To extract colors for dual color copy, adjusting the colors of the document is required
in advance.
Our service representative performs the adjustment. Contact our Customer Support
Center.
îš„Copy with Covers
When you copy a document with the [Cover] feature using the Large Size UI Kit, a back
cover cannot be copied in color.
To copy a back cover in color, use the [Segment Separators] feature under [Build Job].
This restriction is not applied when you select [Back Cover] from the Middle Size Color
UI or select [Front Cover] from the Large Size UI Kit.
îš„Pages per Side for Black & White and Color Mixed Documents and Meter Count
If you copy a document that contains black & white and color pages by specifying
[Pages per Side], an output sheet that has both black & white and color pages will be
counted as a color page.
îš„Copy and Simple Copy
You cannot switch the screen between the Copy and Simple Copy services. Return to
the [Services Home] screen, and then select a service. In that case, the settings
specified in either service are cleared.
îš„ID Card Copy
z
The machine does not shift the ID card image to the center of the output in any
magnification ratio and image size you specified.
To Next Page
Loading...
Need help?
General
