16 Appendix
688
Appendix
16
z
On the [Job Status] screen, jobs listed in [Active Jobs] or [Completed Jobs] fill the
entire screen. Therefore, the date and time are not displayed on the [Job Status]
screen.
îš„Operations during the Energy Saver mode
z
It takes about five seconds before you can operate the system settings under [Tools]
after the machine exits the Sleep mode.
z
The <Energy Saver> button still lights up when you perform the operations which do
not light up the touch screen such as printing command from a computer.
z
A message does not appear on the touch screen if you open and close the top cover
of the document feeder when the document feeder is deactivated (such as when the
service to use a scanner is not selected). However, the confirmation message
appears on the touch screen and the <Error> indicator lights up when the document
feeder is activated (exits the Energy Saver mode) while the top cover is open.
z
The confirmation indicator does not light up if the document is loaded while the
document feeder is in the Energy Saver mode (such as when the service for
scanning is not selected). However, the confirmation indicator lights up and the
document is detected when you load the document and then make the machine exit
the Energy Saver mode.
z
The machine exits the Energy Saver mode when you open the document cover to
copy or scan.
z
After the machine exits the Energy Saver mode, the document feeder and scanner
device are activated after the document cover is opened while the scanner device is
deactivated. However, to make the document detected on the document glass, make
sure that the scanner device in the document glass moves to the detect position for
the document size, and then close the document cover.
z
After the machine is activated from the Energy Saver mode, a message does not
appear on the touch screen if you perform the following operations while the service
to be used for the output device, such as copying and secure printing, is not selected.
- Opening and closing the top cover of the document feeder
- Opening and closing the front cover
- Opening and closing the bottom left cover
- Opening the paper tray
- All the operations including opening and closing the front cover of the finisher, and
pressing the buttons
However, the confirmation message appears and the <Error> indicator lights up
when the machine is activated (exits the Energy Saver mode) while each cover or a
paper tray is open.
z
After the machine exits the Energy Saver mode, the value detected before the
machine enters the Energy Saver mode is displayed or informed as paper tray status
and the information on the consumables such as the toner remaining amount, status
of the drum cartridge, and paper, if the service used for the output device is not
activated.
z
After the machine exits the Energy Saver mode, be careful for the following if you use
the copy feature before you activate the service used for the output device.
The information displayed such as a paper size specified for the paper tray or the
remaining amount is detected before the Energy Saver mode. If you change the
paper size or remaining amount during the Energy Saver mode, it takes about five
seconds for the change to be updated on the screen.
To Next Page
Loading...
Need help?
General
