3 Maintenance
88
Maintenance
3
5 Push a new staple cartridge into the unit.
6 Push the removed unit back to the original
position.
7 Close the right cover of the finisher.
Note • A message will be displayed and the machine will not operate if the right cover of the finisher
is even slightly open.
Emptying the Punch Scrap Container for Finisher C2 or Finisher C2 with Booklet Maker
When the Finisher C2 (optional) or Finisher C2 with Booklet Maker (optional) is
installed and the punch scrap container becomes full, a message appears on the touch
screen. Discard the scraps according to the message.
If you take the punch scrap container out of the machine, make sure to empty it
completely. If it is reinstalled with some scraps remaining, it may become full before the
message appears again, and this can cause machine breakdown.
Important • When emptying the punch scrap container, make sure that the machine is switched on. If not
switched on, the machine will not recognize that the punch scrap container has been
emptied.
• When the machine is in the Energy Saver mode, exit the Energy Saver mode by pressing
the <Energy Saver> button and the <Machine Status> button on the control panel before
you empty the punch scrap container.
• Before emptying the punch scrap container, press the <Machine Status> button and check
the current status for the punch scrap container even when the control panel is lit.
1 Make sure that the machine has stopped,
and open the front cover of the finisher.