Cleaning the Machine
95
Maintenance
3
Cleaning the Constant Velocity Transport Glass and Document Presser
If the constant velocity transport glass and document presser are dirty, streaks or
smears may appear on copies and the machine may not properly detect document
sizes.
To ensure clean copies at all times, clean the constant velocity transport glass and
document presser about once a month.
Important • Do not use benzene, paint thinner, or other organic solvents. Doing so might damage paint
or coating on plastic parts.
• Cleaning the machine with an excessive amount of water may cause the machine to
malfunction or damage documents during copying.
1 Wipe the constant velocity
transport glass, and document
presser, and the guide with a soft
cloth moistened with water to
remove any dirt, and then wipe
them with a soft, dry cloth.
Important • Do not use cleaning agents
other than water or neutral
detergent.
Note • If dirt does not come off easily, gently wipe it with a soft cloth moistened with a small amount
of neutral detergent.
2 Holds the lever to open the chute.
Wipe the constant velocity
transport glass with a soft cloth
moistened with water to remove
any dirt on the optical glass, and
then wipe it with a soft, dry cloth.
Important • Do not push the constant
velocity transport glass
strongly since it is easy to
damage the film around the
optical glass surface.
• Do not use cleaning agents other than water or neutral detergent.
Note • If dirt does not come off easily, gently wipe it with a soft cloth moistened with a small amount
of neutral detergent.
3 Push the center-left side of the document cover to close the belt area until it clicks into
place.
Cleaning the Document Feeder Roller
If the document feeder roller is dirty, streaks or smears may appear on copies, faxes,
or scanned documents and paper jams may occur.
To ensure clean copies at all times, clean the document feeder roller about once a
month.
Important • Do not use benzene, paint thinner, or other organic solvents. Doing so might damage paint
or coating on plastic parts.
• Cleaning the machine with an excessive amount of water may cause the machine to
malfunction or damage documents during copying or printing.
Document
presser
Constant
velocity
transport glass
Guide
Chute
Constant
velocity
transport glass