Replacing Consumables
89
Maintenance
3
2 Pull out the punch scrap container R4
towards you.
3 Discard all the scraps.
4 Insert the empty punch scrap container into
its original position until it comes to a stop.
5 Close the front cover of the finisher.
Note • A message will be displayed and the machine will not operate if the front cover of the finisher
is even slightly open.
Emptying the Punch Scrap Container for Finisher D2-P with Booklet
Maker
When the Finisher D2-P with Booklet Maker (optional) is installed and the punch scrap
container becomes full, a message appears on the touch screen. Discard the scraps
according to the message.
If you take the punch scrap container out of the machine, make sure to empty it
completely. If it is reinstalled with some scraps remaining, it may become full before the
message appears again, and this can cause machine breakdown.
Important • When emptying the punch scrap container, make sure that the machine is switched on. If not
switched on, the machine will not recognize that the punch scrap container has been
emptied.
• When the machine is in the Energy Saver mode, exit the Energy Saver mode by pressing
the <Energy Saver> button and the <Machine Status> button on the control panel before
you empty the punch scrap container.
• Before emptying the punch scrap container, press the <Machine Status> button and check
the current status for the punch scrap container even when the control panel is lit.
To Next Page
Loading...
Need help?
General
