Fuji Xerox ApeosPort-IV C7780 Administrator's Guide

Installation When Using Internet Printing Protocol (IPP)
313
Printer Environment Settings
7
Installation When Using Internet Printing Protocol (IPP)
This section describes how to install the machine using Internet Printing Protocol (IPP).
The following shows the reference section for each procedure.
Step 1 Preparations................................................................................................................... 313
Step 2 Configuration on the Machine ...................................................................................... 313
Step 3 Configuration on the Computer .................................................................................... 314
CentreWare Internet Services Setting Items ............................................................................ 314
Note • If the size of print data sent via IPP is larger than the value set in the proxy server, the
machine cannot receive the data. In this case, set a larger value in the proxy server or
change your browser setting not to use the proxy server.
Step 1 Preparations
The following items are required to set up the machine to use Internet Printing Protocol
(IPP).
z
TCP/IP network environment
z
The Driver CD Kit (provided with the machine)
Step 2 Configuration on the Machine
The following describes the configuration procedures to use Internet Printing Protocol
(IPP) on the machine. Enable the IPP port, and then configure TCP/IP settings.
Note • You can configure the settings using CentreWare Internet Services or the Driver CD Kit.
For the items that can be configured using CentreWare Internet Services, refer to "CentreWare Internet
Services Setting Items" (P.314). For information on how to configure the setting using the Driver CD
Kit, refer to the manual contained in the Driver CD Kit.
1 Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator’s user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator’s
passcode, and select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3) Select [Tools] on the [Services Home] screen.
2 Enable the IPP port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [IPP], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
6) Select [Close] repeatedly until the [Tools] screen is displayed.

Fuji Xerox ApeosPort-IV C7780 Specifications

General

Brand	Fuji Xerox
Model	ApeosPort-IV C7780
Category	All in One Printer
Language	English